Resolution of Chronic Cooling Tower Fan Vibrations

Traditional rotating equipment mounted at grade use the mass of a foundation and grout to reduce vibration and provide support and stiffness. However, cooling tower fans must be elevated many feet above a basin of water which sometimes puts them “out of sight and out of mind”. Cost and practicality prohibits concrete and grout, thus […]

Continue Reading

Process Centrifugal Compressor Oil Seals

Ingersoll Rand Cone Oil Seals Compressor process shaft end seals are designed to seal the rotating assembly in the stationary compressor case to prevent the process gas in the compressor from escaping to the atmosphere and to prevent the atmosphere from getting into the process gas.   Shaft end oil seals, as compared to the relatively […]

Continue Reading

Reciprocating Compressor Cylinder Alignment (Often overlooked as a failure root-cause)

Compressor cylinder bore misalignment can cause failures that are often not attributed to misalignment. Crosshead shoes uneven wear, compressor piston rod failure at both the crosshead and at the piston, compressor piston rod coating failure, piston wear and compressor cylinder bore wear can all be attributed to cylinder misalignment. The objective of this article is […]

Continue Reading

No Detail or Procedure is Trivial, or, Sophisticated Vibration Analysis is a VERY Cost Effective Diagnostic Tool

Today it is common practice in overhauls of large rotating equipment to spend many man hours in detailed planning, coordination, writing procedures, reviewing documentation, reviewing past photos, procuring and inspecting spare parts etc. We also review our past experience and put steps in place to mitigate past problems or errors.   Now that we have a […]

Continue Reading
Becht default post image

Oil System Cleaning – Making Oil Flushing a Predictable Procedure

Oil system cleaning or Oil Flush has humbled many Machinery Guys. What seems like a very simple task often turns out to be to the Achilles’ heel and often unpredicted and embarrassing critical path of the machinery overhaul. The purpose of this article is to outline improvements that we have implemented to the old-fashion “Flush […]

Continue Reading
Becht default post image

Machinery Hurricane Flood Damage– Innovative Seal Recovery Procedure

Serious floods rarely occur in the life of a refinery or petro-chemical plant. But when such an event does occur there are significant implications for the reliability of rotating equipment and associated business risks when it’s time to restart the plant. And because this scenario is so uncommon, there are few, if any, industry standards […]

Continue Reading
Becht default post image

The Potential Pitfalls of Fabricated Machinery Foundations

A new process unit was designed and built by a petrochemical manufacturer. As part of the project, two 50 horespower blowers were installed. Rotating equipment of this type is traditionally installed at grade on an engineered monolithic concrete foundation with rebar and anchor bolts. A suitable soleplate or baseplate is then grouted to the foundation […]

Continue Reading
Let Becht Turn Your Problem
Into Peace of Mind