Have you noticed, looking at the famous ASME B31.1 support spacing Table 121.5, that the spacing between pipe supports is roughly “size + 10”, in other words, the spacing between supports on an 1 inch instrument tubing would be “1 + 10” = 11 ft, while the spacing on a 6 inch line for example […]
FAILURE MODE – When an explosion (either a subsonic deflagration, or a supersonic detonation) occurs in a metallic vessel, one of three things can happen: Case 1 – Containment: The vessel can contain the explosion, elastically as if nothing happened, or with plastic bulging. Case 2 – Rupture: The vessel can rupture, without ejecting fragments. […]
Ingersoll Rand Cone Oil Seals Compressor process shaft end seals are designed to seal the rotating assembly in the stationary compressor case to prevent the process gas in the compressor from escaping to the atmosphere and to prevent the atmosphere from getting into the process gas. Shaft end oil seals, as compared to the relatively […]
My previous blog on Equipment Health Monitoring (EHM) explains why EHM can be used to improve fatigue life of a coke drums. As explained in this blog, one of the critical locations to be monitored are the circumferential weld seams – where high thermal stresses occur during the operation of the drum. These high stresses over […]
Gerrit Buchheim, Manager of the Pono Division of Becht Engineering, has developed a practical and simple-to-use approach to prioritizing the inspection and replacement of equipment in High Temperature Hydrogen Attack (HTHA) service. This approach utilizes the existing and accepted “Nelson Curve”, but adapts it to better fit the realized operating conditions at an individual facility, […]
I have been receiving many inquiries recently from individuals and companies concerned about the status of OSHA Rule 1926.1427 – All wondering if they are in compliance. Bottom Line – There is currently a nationwide controversy regarding OSHA regulation on crane operators. Background OSHA enacted a new crane rule in 2010. The part 1926.1427 (Crane Operators) […]
In addition to the many clarifications, updated references to codes and standards, updates to basic allowable stresses, and added listed materials, there are several substantive changes to the 2014 Edition of ASME B31.3, Process Piping. These changes are: Category M Fluid Service The definition was revised in the 2014 edition to provide better guidance on […]
As the year draws to a close, I’ve been retrospective — regarding what I have seen in terms of Safety successes. It turns out that it has been a good year for Safety! Having had the opportunity to interact with different operations, companies and a variety of “Safety Cultures”, it is evident to me […]
